You must have a Race Tool Package to use the Pit Speed Limiter Harness. The Pit Speed Limiter harness is used with our Race Tools Package, it consists of a harness and water proof push button switch which allows you to limit the RPM of the bike in 1st gear while riding in the pits.

*** Pit Speed Limiter harness sold separately ** This harness uses the stock O2 Sensor plug on the bike's harness, the stock O2 sensor should be removed from the bike and disabled in our software * Contact us after ordering if you have after-market rearsets or are using a race shift pattern and we will swap the shift rod for a generic rod that can be cut and tapped to the correct length. Pit Speed Limiter allows you to set the RPM to limit the speed while riding through the pits.*** Launch Control allows you to configure Delay, Launch RPM, Ramp Time and Ramp RPM Quickshifter Kill times are configurable per gear with 3D maps allowing Kill Times to be set for the full range of TPS and RPM combinations. Race Tools Key to allow the use of the Race Tools on one ECU in the Woolich Racing Tuned software.Kawasaki Race Tools Harness Type 9 which allows the quickshifter to be plugged into the bikes wiring harness**.Shift rod for standard shift configuration*.High quality strain gauge Quickshifter with digitally controlled pressure sensing that can be used in regular or race shift pattern.The Race Tools package allows you to enable Quickshifter, Launch Control and Pit Speed Limiter in the Stock ECU. If you do not have a Woolich Racing Interface you can also visit a Woolich Racing - Tuning Partner and have them install and configure the Race Tools (additional fees and charges will apply).Ģ017-2019 Kawasaki Z900 Race Tools Package You can purchase this as a package on the product page for your bike. You will need to use the relevant Woolich Racing Interface and Bin File Definition to enable and configure Race Tools and write to the ECU. Woolich Racing Race Tools requires you to Write the ECU.

The Launch Control Key allows you to enable the Launch Control for one ECU. If you already have a Quickshifter or Air Shifter installed on your bike or you only need the Launch Control function you can purchase this Launch Control Key. It allows you to set a Launch RPM and also Ramp Parameters to assist with getting fast consistent launches from your bike, all controlled by the stock ECU. Launch Control is part of the our Race Tools Package. Race Tools: Quickshifter, Launch Control, Pit Speed LimiterĢ017-2019 Kawasaki Z900 Launch Control Key

Z900 ecu flash